lb.00056.30 Pag. 10 26/05/10
WASHING
1) Washing the group and filter holder.
It is advisable to carry out these types of washing at the end of each working day.
1a) washing the filter holders.
Carry out the following operations:
Remove the filters from the filter holders and wash both parts under running water.
Remove the remaining coffee using a cloth.
If the filters get clogged up and you cannot manage to clean them by washing, it is advisable to place it under a naked flame to burn any
coffee particles remaining in the holes.
This operation should not be carried out frequently, as it may damage the filter.
1b) washing the group gasket.
Carry out the following operations:
Insert the blind filter membrane supplied in the filter holder.
- Turn the machine Off;
- While keeping the key N. 7 pressed, press the key N. 1 of the group you want to clean. The group will dispense at pulses for a total
duration of 90 seconds;
- Slightly open and close the filter holder a few times, letting the water flow out. Be careful not to let hands and other parts of the body
come into contact with water, in order to avoid danger of burns;
- If necessary repeat this operation several times, and remove the remaining coffee from the group gasket using a cloth.
PLEASE NOTE: Only for Eta Beta 2-3 groups.
1c) washing the third duct of the group.
Carry out the following operations:
- Insert the blind filter membrane supplied in the filter holder;
- Turn the machine Off;
- While keeping the key N. 7, press the key N. 1 of the group you want to clean. The group will dispense at pulses for ten times for a
total duration of 90 seconds.
PLEASE NOTE: Only for Eta Beta 2-3 groups.
2) washing the cappuccino maker.
We recommend carrying out this type of washing several times a day.
Carry out the following operations:
- Turn the machine Off;
- Insert the milk suction tube in a glass of cold water, containing detergent;
- While keeping the key N. 7 pressed, press the key N. 6 of the group where you want to clean the cappuccino maker. The
cappuccino maker will dispense steam at pulses for a total duration of 60 seconds.
PLEASE NOTE:
a) Only for Eta Beta 2-3 groups;
b) At the end of each working day, the cappuccino maker should be dismantled and cleaned by hand using a detergent. Take care in
reassembling the cappuccino maker parts correctly.
To Next Page