Carlisle DeVilbiss PROLite Series - Page 3

EU Declaration of Conformity
Product Description / Object of Declaration:
15/5/20
This Declaration of conformity /
incorporation is issued under the sole
responsiblity of the manufacturer:
Notified body details and role:
Carlisle Fluid Technologies UK Ltd,
Ringwood Road,
Bournemouth, BH11 9LH. UK
Providing all conditions of safe use / installation stated within the product manuals have been complied with and
also installed in accordance with any applicable local codes of practice.
ATEX Directive 2014/34/EU
Machinery Directive 2006/42/EC
By complying with the following statutory documents and harmonised standards:
EN 1127-1:2011 Explosive atmospheres - Explosion prevention - Basic concepts
BS EN 1953:2013 Atomizing and spraying equipment for coating materials - Safety requirements
EN ISO 12100:2010 Safety of Machinery - General Principles for Design
EN ISO 80079-36:2016 Explosive Atmospheres- Part 36:Non Electrical equipment for explosive atmospheres-
Basic methods and requirements.
EN ISO 80079-37:2016 Explosive Atmospheres- Part 37: Non Electrical equipment for explosive atmospheres -
protection by methods "c", "b" and "k".
HVLP and High Efficiency products comply with the requirements of PG6 from the EPA guidelines and offer
greater than 65% transfer efficiency.
High volume, low pressure (HVLP) sprayguns are designed to reduce overspray and provide maximum transfer
efficiency by limiting air cap pressure to 0.69 bar (10 psi) (complies with rules issued by SCAQMD and other
authorities). Gun inlet pressure must not exceed 24 psi when using the HVLP cap HV30 to maintain compliance.
Air cap test kit 703541 is available to set the exact cap pressure.
For North America only, the TE10 and TE20 air caps are only approved for the application of color coatings and
clearcoats in regulated areas. For compliance in regulated areas, this spray gun must be used with a DeVilbiss
spray gun mounted air adjusting valve (HAV-512, HAV-555, or DIGIPRO-504-PSI) which is in good working
order. For compliance the inlet pressure must not exceed 35 psi with the TE10 aircap or 26 psi with the TE20 air
cap. Item 9 must also be removed for compliance. This gun can also be used in unregulated areas with either air
cap while using any coating.
For North America only, the TE25 air cap is only approved for the application of clearcoats in regulated areas.
For compliance in regulated areas, this spray gun must be used with a DeVilbiss spray gun mounted air adjusting
valve (HAV-512, HAV-555, or DIGIPRO-504-PSI) which is in good working order. For compliance the inlet
pressure must not exceed 26 psi when used with the TE25 air cap. This gun can also be used in unregulated
areas with the TE25 air cap while using any coating.
II 2 G X/Ex h II Gb X
Element Materials Technology (0891)
Lodging of Technical file
Protection Level:
Signed for and on behalf of Carlisle Fluid
Technologies UK Ltd:
M.Munoz
Vice President of Engineering
The object of the declaration described above is in conformity with the relevant Union
harmonisation legislation:
PROLite G, PROLite P/S, PROLite-S, GPG & FLG
This Product is designed for use with:
Solvent and waterborne materials
Suitable for use in hazardous area:
Zone 1 / Zone 2
SB-E-2-996 R1.0
3/24
www.carlisleft.com