3
PRE-INSTALLATION INFO
CHECK CONTENTS
Separate all parts from the packaging and check each part with the pack contents section. Pay attention to the
variations of the dierent models.
Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic outlet until you obtain the missing parts.
WARNING
) To avoid reflection problems keep a distance of more than mm. between
the washbasin and the spout.
) This outlet model, with an infrared sensor pointing down, is not intended
to be used together with a washbasin of a reflective material such as
stainless steel.
) If a washbasin strainer is straight below the outlet sensor, use a strainer with
a non reflective nish (do not use a chrome plated one).
Min mm.
Bottom of the washbasin
PREPARATION FOR INSTALLATION
Flush the water supply lines thoroughly before installing the outlet. Do not allow dirt, teflon tape or metal particles
to enter the outlet. Shut o water supply.
IMPORTANT: All plumbing is to be installed in accordance with applicable codes and regulations.
Installations in Australia and New Zealand must comply with the requirements of AS/NZS .
To Next Page
Loading...
Need help?
General
