How to Assemble and Operate the Vacuum
How to Attach the Handle to the Vacuum Cleaner
The vacuum cleaner and the handle are packed separately.
1. After first removing the handle screw, insert handle into the hole
on top of the vacuum cleaner. Make sure that the cord hooks on
the handle are positioned to the back of the vacuum cleaner
(Fig. 1).
2. Line up the small hole on the handle with the small hole on the
vacuum cleaner and insert the screw. Make sure the screw is
tightened securely.
3. Turn the upper cord storage hook to the upright position and wind the
power cord around the cord storage hooks when storing the
vacuum cleaner (Fig. 2).
How to Release the Power Cord
1. The upper cord storage hook has a quick-release action.
To release the cord, rotate the hook downward and the cord will
drop off the handle for immediate use (Fig. 3).
2. Return the hook to the upright position before attempting to
rewind the cord.
On/Off Switch (Fig. 4)
1. To turn the vacuum on, push the switch located on the dust
compartment to the ( I ) position.
2. To turn the vacuum off, push the switch located on the dust
compartment on the ( 0 ) position.
Fig. 1
Fig. 2
Fig. 3
5
Fig. 4
How to Change the Vacuum Bag
Always operate the vacuum cleaner with a vacuum bag installed.
How to Change the Vacuum Bag
1. Unplug the vacuum cleaner. Remove the bag compartment cover
and remove the used bag from the bag holder (Fig.1).
2. Attach the new vacuum bag onto the bag holder (Fig. 2).
3. Pull the bottom corners of the new vacuum bag (Fig. 3).
4. Reinsert the tab on the end of the bag compartment cover into the
groove on the bag compartment housing. Press it into place and
fasten the bag compartment cover latch tightly (Fig. 4).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
To Next Page
Loading...
Need help?
General
