6
How to Attach the Handle to
the Vacuum Cleaner
Model: CPU-3QD
The vacuum cleaner and the handle are
packed separately.
1. Remove the handle screw, insert
handle into the hole on top of the
vacuum cleaner (Fig. 1).
2. Line up the small hole on the handle
with the small hole on the vacuum
cleaner, and insert the screw. Make
sure the screw is tightened securely.
How to Attach the Extension
Power Cord to the Cord Lock
1. Connect the extension power cord to
the pigtail cord on thevacuum.
2. Snap the extension power cord into
the slot on the end of the cord lock.
3. Turn the knob on the bottom of the
cord lock to tighten the lock and
prevent the cords from pulling apart
(Fig. 2).
How to Attach the Cord to the
Retainer Hook on the Handle
1. Create a loop in the power cord,
and push it through the slot and over
the hook of the cord retainer (Fig. 3).
2. Pull down on the power cord to
remove any slack (Fig. 4).
On/Off Switch
1. To turn the vacuum on, push the switch
located on the dust compartment to the
( I ) position (Fig. 5).
2. To turn the vacuum off, push the switch
located on the dust compartment on
the ( 0 ) position.
Fig. 1
Fig. 2 Fig. 3
Fig. 4 Fig. 5
HOW TO ASSEMBLE AND OPERATE THE VACUUM
To Next Page
Loading...
Need help?
General
