Replacing the shaving foil frame and the cutter block
Do not use the product if the shaving foil or the cutting block (20)
are damaged. If
- you notice any damage,
- your skin hurts when shaving
- you do not get a clean shave,
then the shaving foil and the cutter block must be replaced. The
amount of wear and tear depends on the usage intensity, but in
general the components must be replaced after approximately
one year.
1.Press both release buttons for the shaving head (5)
and pull the shaving head off. Press both release
buttons for the shaving foil frame (2) and pull the
shaving foil frame off the head. Replace the shaving
foil frame with a new one.
2.Press both release buttons. Hold the cutter block
between your thumb and forefinger and pull it carefully
off the razor. Make sure that the spring that is located
between the cutter block and the white bracket does
not fall out.
3.Hold the new cutter block between your thumb and
forefinger and guide it carefully into the white
bracket. Push it down as far as it will go, until it
audibly clicks into place on the cutter block mount (21).
4.Put the shaving head with the foil on back in place.
Note: use replacement parts for CARRERA shavers
(purchased separately).
20
21
CAUTION!
• Never immerse the appliance in water.
• Do not use any corrosive or abrasive cleaning agents.
This might damage the surface of the appliance.
• Do not apply strength to the shaving foil, as it can be
easily damaged.
EN 10
To Next Page
Loading...