NOTES:
1. REPLACEMENT OF ORIGINAL WIRES MUST BE WITH TYPE 105°C WIRE
OR ITS EQUIVALENT.
2. FACTORY WIRING IS IN ACCORDANCE WITH NATIONAL ELECTRICAL CODE (NEC)
U.S.A. FIELD MODIFICATIONS OR ADDITIONS MUST BE IN COMPLIANCE WITH
ALL APPLICABLE CODES.
3. WIRING FOR MAIN FIELD POWER SUPPLY MUST BE RATE 75°C MINIMUM.
USE COPPER FOR ALL UNITS. MAXIMUM INCOMING WIRE SIZE FOR EACH
TERMINAL IS #4AWG UP TO 100A AND 350KCMIL GREATER THAN 100A UP TO 200A.
To Next Page
Loading...