Carrier 16JA User Manual

General overview of machine start-stop systems.

Describes operation via automatic controller.

Describes operation with manual start.

Details starting manual auxiliaries in semiautomatic systems.

Differentiates start-up based on shutdown duration.

Procedures for starting after short shutdowns.

Procedures for starting after long shutdowns.

Steps for shutdown based on ambient temperature.

Steps for start-up after winter shutdown.

Explains the functions of the 16JA purge unit.

Explains causes and effects of solution solidification.

Steps to resolve pump solidification.

Routine steps for preventive maintenance.

Steps for reclaiming lithium bromide solution.

Checking vacuum tightness and accumulation rate.

Procedure to check dilution thermostat setting.

Procedure to check low-temperature cutout.

Procedure to check evaporator water charge.

Steps to adjust electronic capacity control.

Steps to adjust pneumatic capacity control.

Checking and recalibrating bypass control.

Procedure to check for scale in tubes.

Procedure for recharging lithium bromide.

Requirements and procedures for diaphragm replacement.

Procedures for inspecting hermetic pumps.

Steps for disassembling the pump.

Steps for inspecting pump components.

Steps for reassembling the pump.

Procedure for adding octyl alcohol.

Importance and use of log sheets.

Information required for ordering parts.

General introduction to troubleshooting.

Causes and remedies for solidification at start-up.

Causes and remedies for solidification during operation.

Causes and remedies for low machine capacity.

Causes and remedies for safety control shutdowns.

Causes and remedies for solidification during shutdown.

Causes and remedies for suspected air leaks.

Causes and remedies for vacuum loss at shutdown.

Causes and remedies for purging failures.

Explanation of the equilibrium diagram and its use.

Explains the basic flow and operation of the cycle.

Details how capacity control functions.