To Next PageTo Next PageWhat to do if my Carrier 25HPA6 Heat Pump detects a 230V line (power disconnect) issue?
If your Carrier Heat Pump detects a 230V line (power disconnect) issue, verify that the disconnect is closed and the 230v wiring is connected to the unit.
What to do if Pressure Switch Protection activates on my Carrier Heat Pump?
If the Pressure Switch Protection activates on your Carrier Heat Pump, take the following steps: * Check the refrigerant charge. * Check the outdoor fan operation. * Inspect the outdoor coil (in cooling) for airflow restrictions, or indoor airflow in heating. * Check the indoor airflow (cooling) and outdoor fan operation and outdoor coil in heating.
How to troubleshoot no 230V at compressor contactor in Carrier 25HPA6?
If there's no 230V at the compressor contactor in your Carrier Heat Pump, check the contactor and control box wiring.
How to fix a Systems Communication Failure in Carrier 25HPA6?
To address a Systems Communication Failure in your Carrier Heat Pump, check the wiring to the User Interface and the indoor and outdoor units.
What happens when my Carrier Heat Pump detects a shorted contactor?
When your Carrier Heat Pump detects a shorted contactor, the control will de-energize the compressor contactor for 15 minutes but continues to operate the outdoor fan.
What to do if my Carrier Heat Pump has a Control Fault?
If your Carrier Heat Pump has a Control Fault, the control board should be replaced.
Unpack and inspect unit, and check rating plate for job specifications.
Mount unit securely on a level pad, considering local codes and wind for stability.
Ensure adequate space for airflow, wiring, piping, and service access for proper operation.
Install the required liquid-line filter drier in the liquid line for proper operation.
Connect vapor and liquid tubing to the outdoor unit service valves.
Follow safety precautions when brazing refrigerant tubing connections.
Evacuate the system using the deep vacuum method to 500 microns for moisture removal.
Wire ground, power, and control circuits according to diagrams and codes.
Configure blower airflow for ECM and variable speed furnaces based on cooling stages.
Follow safety and operational procedures during system start-up.
Understand how the system operates in cooling and heating stages.
Details on low ambient cooling capabilities and enablement with Infinity Control.
Explanation of defrost intervals, demand criteria, and termination conditions.
Overview of key components like the control board, compressor, and contactor.
Diagnosing and resolving system issues using status codes and checks.
How high and low-pressure switches monitor and protect the unit.
Detecting contactor issues, voltage problems, and compressor operation faults.
Details on thermistors for sensing air and coil temperatures.
Unit behavior when OAT or OCT sensors fail.
Interpreting amber LED flashes for system diagnostics and fault identification.
Detailed fault codes, operations, and possible causes/actions for system issues.
Wiring diagram for non-communicating thermostats with 2-stage heat pump connection.
Wiring diagram for non-communicating thermostats with furnace and heat pump.
Wiring diagram for Infinity control setup with a communicating heat pump.
Essential checks to perform before leaving the job site for proper installation.
Guidelines for continuing high performance and minimizing equipment failure.
Key information for servicing Puron (R-410A) refrigerant systems.
General
