Carrier 30RB060-390 - Page 18

18
5975.08
235.24[]
408.89
16.10[]
UNIT MOUNTING
2769.30
109.03[]
408.89
16.10[]
422.24
16.62[]
2073.54
81.64[]
2281.37
89.82[]
864.00
34.02[]
2016.54
79.39[]
800.00
31.50[]
101.20
3.98[]
2236.08
88.03[]
CG
y
CG
x
1447.80 [57.00]
200.00
7.87[]
100.00
3.94[]
1773.54
69.82[]
246.36
9.70[]
190.00
7.48[]
336.50
13.25[]
UNIT MOUNTING
2388.00
94.02[]
400.00
15.75[]
200.00
7.87[]
240.00
9.45[]
39.89
1.57[]
UNIT MOUNTING
2156.30
84.89[]
PIPING ENTRANCE AREA
600.00 23.62[]
191.86
7.55[]
PIPING ENTRANCE AREA
631.30
24.85[]
400.00 [15.75]
553.81
21.80[]
343.81
13.54[]
2X 343.33
13.52[]
3344.61
131.68[]
1892.75
74.52[]
4459.11
175.56[]
PIPING ENTRANCE AREA
600.00
23.62[]
587.63
23.14[]
2X 503.37
19.82[]
2X 769.85
30.31[]
5087.45
200.29[]
938.35
36.94[]
215.71
8.49[]
38.00
1.496[]
WEIGHT
MCHX
lb/kg
CENTER OF GRAVITY
CGx
MM [INCH]
CGy
MM [INCH]
30RB-160
315A/B,330B
10991
4986
3124
[122.99]
1001
[39.41]
30RB-170
330A,345A/B,360B
11315
5133
3168
[124.74]
986
[38.82]
AIR FLOW
COOLER TUBE SERVICE AREA
SERVICE AREA 1219.2[48.0] FROM EACH SIDE OF THE UNIT
A
A
VIEW-A-A
COOLER VENT 1/4" NPT
COOLER DRAIN 3/4" NPT
COOLER ENTERING WATER 6" VICTAULIC
COOLER LEAVING WATER 6" VICTAULIC
CONDENSER DRAIN 3/8" NPT
SCROLLING MARQUEE
DISPLAY
FIELD CONTROL WIRING
FAN ELECTRICAL BOX
(FEB)
ALL VOLTAGES
BACnet COMMUNICATION OPTION KNOCKOUT FOR 1/2" CONDUIT
POWER BOX 230V ONLY (CKT A)
7/8" KNOCKOUT TO BE
USED FOR LOCATING FIELD POWER WIRING
(DUAL POINT 230V ONLY)
CIRCUIT A
COMPRESSORS
CIRCUIT B
COMPRESSORS
HR CONDENSER TUBE
SERVICE AREA
SEE DETAIL
B
7/8" KNOCKOUT TO BE USED FOR LOCATING FIELD POWER WIRING (DUAL AND SINGLE POINT)
POWER BOX 230V (CKT B) POWER BOX 380V,460V,575V (CKT A,B)
DETAIL
B
SCALE 3:16
22.2 [.87]
MOUNTING HOLE
CONDENSER LEAVING WATER 5.0" VICTAULIC
CONDENSER ENTERING WATER 5.0" VICTAULIC
CONDENSER VENT 1/4" NPT
NOTES:
1. Unit must have clearances as follows:
Top — Do not restrict. Sides and End — 6 (1.8 m) from solid surface.
2. Temperature relief devices located on suction line, liquid line and filter drier
of each circuit and have
1
/
4
flare connection.
3. Dimensions are in mm [inches]. 4. Allow 8 ft (2.4 m) of service access on either side of unit for condenser coil
removal.
a30-4739
LEGEND HR — Heat Reclaim MCHX — Microchannel Condenser Coil
Fig. 14 — 30RB160,170 Air-Cooled Chiller with Heat Reclaim Option Dimensions