Carrier 40 series - Setting Current Time; Operating Mode Selection; Temperature Setting

3
3
Setting current time
10 2 3 S
1
With the remote control ON or OFF, press button [10] for at
least 5 seconds.
The displayed current hour [S] figure flashes.
2
Press either button [2] or [3] to set the desired value.
3
Press button [10] to confirm. The minutes figure flashes.
4
Press either button [2] or [3] to set the desired value.
5
Once the current time is set, press button [10] to confirm.
Operating mode selection
4 A1 A2 A3 A4 A5
By repeatedly pressing button [4] the available modes will be selected
in sequence.
The choosen mode is shown on the display as follows, while the unit
will acknowledge signal receipt with a confirming beep.
1a
[A1] Ventilation (fan only)
1b
[A3] Automatic (set the right mode for the desired
temperature)
1c
[A4] Cooling with dehumidification
1d
[A5] Dehumidification only
1e
[A2] Heating (if available)
Temperature setting
2 3 C E
F
F
Press the UP [2] and DOWN [3] buttons to increase or decrease the
temperature from the previously set value.
Note
The unit will confirm signal receipt with a beep, and the value
of the set temperature on the display will change accordingly.
The temperature can be set between 17°C (63°F) and 32°C
(90°F) at 1 degree intervals.
In cooling mode, if the temperature selected is higher than the
room temperature the unit will not start; the same applies for
the heating mode, if the selected temperature is lower than
the room temperature.
English