Carrier Enterprise
Technical Services
Basic Operation:
1. Turn ON the remote control by pressing the ON/OFF button.
2. Select the MODE be pressing the MODE button.
• AUTO, COOL, DRY, HEAT, FAN are selectable modes of operation.
• AUTO is not available on Heat Pump Systems.
• FAN speed cannot be adjusted in DRY mode.
3. Select FAN speed.
• AUTO, LOW, MED, HIGH are selectable fan speeds.
4. If AUTO, COOL, DRY, HEAT mode is selected, set desired temperature.
5. In AUTO mode, press LEFT or RIGHT buttons within 10 seconds to switch
between cooling & heating set points.
More detailed information on these items and more can be found in the Installation and
Operation Manual that came with the remote controller. If lost contact CE Tech Services
with model number for replacement.
Page 1 of 5Ver. 1.0
Carrier Bryant VRF Remote
Control Quick Startup Guide
1 – MODE Selects the running mode.
2 – TEMP UP Increases set temperature
3 – ON/OFF Button Powers the IDU on/off
4 – LED (green) Indicates when the IDU is
ON and blinks when there is a fault
5 – Left Selects options to the left
6 – MENU/OK Enters the menu/sub menu &
Confirms selection
7 – Right Selects options to the right
8 – Fan Selects fan running speed
9 – BACK Returns to the previous level
10 – TEMP DOWN Reduces the set
temperature
All display icons are explained
on page 4 of this document.
1 43
7
2
65
8 9
10
40VM900003 – Remote Controller
To Next Page
Need help?
General
