Carrier Enterprise
Technical Services
Page 2 of 5
Menu Operations:
1. Press the MENU/OK button
to enter the menu.
2. Press TEMP UP and DOWN
to select desired menu item.
• If IDU does not have an integral louver, the louver function will not be
available.
3. Set DATE & TIME.
4. Set DAYLIGHT SAVINGS TIME.
5. Set DISPLAY CONFIGURATION. Select Standard or Simple.
• When the indoor temperature display is set, the current room temp
will be displayed below the set point temp(s) on the main display.
Service & Startup Settings:
1. Press and hold the BACK button and
the FAN button for 5 seconds at the
same time to enter SERVICE Settings.
2. From this menu many settings can be
preformed. Most commonly used are;
ROOM TEMPERATURE SENSOR LOCATION, SETPOINT LIMIT, DRY
CONTACT & IDU ADDRESSING
3. IDU Addressing – Press TEMP DOWN button until IDU Addressing is
highlighted and press MENU/OK button to enter.
4. Press TEMP UP or TEMP DOWN to select desired IDU address and press
MENU/OK button to lock in.
5. See last page of this document for all SERVICE items.
Carrier Bryant VRF Remote
Control Quick Startup Guide
To Next Page
Loading...
