Carrier 40MBCQ - Page 13

13
Fig. 27 - Connect the two louver connectors
Fig. 28 - Connect display panel connectors
Grille Louver Motor Power.
5 Pin Port
Grille Display
10 Pin Port
CN40 Connector
Used for Wired Remote Control with
a 4 Pin Molex plug
Wired Remote Controller
(Available as Accessory)
5 Pin Molex plug to be
connected to Wired
Controller’s cable
Grille Display.
10 pin Molex plug to be
connected to Control Board.
Grille Louver Motor Power.
5 Pin Molex plug to be
connected to Control Board
Fig. 29 - Panel Cassette Connections