Carrier 42HQG018 - Page 21

20
(5) Discharge Air Louver Control

Up and Down Control
The air discharge direction can be controlled to swing up and down and can be fixed at
preferred position or automatic position by the remote control.
• If you select the Flap position using the FLAP button in the remote control, the flap in
the unit will move to that position automatically. Once you select the position, the unit
remembers that position and whenever you turn on the unit, the flap will be positioned
to that position.
• If you select SWING, the flap will swing up and down. In the COOL, DRY and FAN
mode, the flap will swing in the cool range. In the HEAT mode, the flap will swing in the
heat range.
• If you select AUTO, the flap will position itself to the preset position according to the
operation mode.
NOTE
• Always use the remote control to adjust the flap position, otherwise it may cause
abnormal operation. Please turn off the unit and turn it on again when you manu-
ally adjust the flap out of range.
• The unit can have maximum capacity when the flap is located at position
.
6
1
2
3
4
5
6
3
4
5
6
CLOSE
A
B
Fixed
Swing Range
Auto Position
Cooling Only Model
AUTO
SWING
FLAP
6
5
4
3
2
1
Remote control
6
3
4
5
6
Fixed Swing Range Auto Position
Heat Pump Model
2
1
COOL
HEAT
2
COOL
HEAT
1
2
3
4
5
6
CLOSE
A
B
AUTO
SWING
FLAP
6
5
4
3
2
1
Remote control
MODEL A B
42HWG007/009/012
HWG195C/225C/305C 54° 36°
42HWG018/024
HWG455C/605C 66° 24°
MODEL A B
42HQG007/009/012, HWG195H/225H/305H 54° 36°
42HQG018/024, HWG455H/605H 66° 24°