e Display and Receiver PCB (Component side)
4) LCD PANEL TEST
a
Selecting the test mode
: Press the LCD test key (K15) in remote control PCB during OFF mode
b T
est mode cancellation
– After the test program is completed.
– If the reset button is pressed.
c
LCD panel test flow
When this key is pressed, the LCD segment test is performed to verify the integrity of
LCD panel as described and then reset.
TEST START BLOCK ‘A’ ON/OFF BLOCK ‘B’ ON/OFF
BLOCK ‘C’ ON/OFF BLOCK ‘D’ ON/OFF RESET MODE
A
B
C
D
OFF
ON
AM
PM
AM
PM
FLAP
ON
AUTO
SLEEP
EVERYDAY
SWING
49
To Next Page
Loading...
