Carrier 42HQG018 - EXPLODED DIAGRAM AND PARTS LIST

5. Removing the indoor coil.
(1) Turn the unit over and you will find one screw for insert
body.
(2) Remove one screw and detach insert body. (fig. 7)
(3) Turn the unit over again and remove three screws from
the coil.
(4) Detach coil by pulling the snap-fit out from the unit.
(fig. 8)
6. Removing blower and fan motor.
(1) Detach bearing bracket by removing one screw from
the body. (fig. 9)
(2) Loosen a set-screw inside the blower with hex key
wrench(M3). (fig. 10)
(3) Pull the blower out.
(4) Detach motor bracket L and R by removing two
screws from the body. (fig. 11)
(5) Pull the motor out.
Fig. 5
Fig. 9
Fig. 10
PROCEDURES PHOTOS
Fig. 6
Fig. 7 Fig. 8
Fig. 11
62