∗ Restriction ratio setting for save operation (DN code No. [C2]) can be set/changed from the normal DN setup
(Detail DN setup).
DN
42
C2
CC
Cd
d0
d1
d3
d4
F6
Item
Self-clean operation time
Current demand X% to outdoor unit
Setting of self-clean operation forced stop
Self-clean operation stop function when
[ON/OFF] operation is prohibited.
Existence of remote controller save function
Existence of 8°C heating operation function
Rotational speed of self clean operation
Display / No display of
[Dry operation] during self clean operation
Presence of Application control kit
Contents
0001: 0.5 h ~ 0012: 6.0 h0000: None
Set when compressor-ON time is 10 to 60 minutes.
When ON-time is 60 minutes or more,
the double of this operation time setting is set.
0050: 50% to 0100: 100%
0000: None
• Clean operation is performed in case of stop by HA input.
• HA operation output OFF during clean operation in case of
stop by remote controller
0001: Stop
• Clean operation is not performed in case of stop by HA input.
• HA operation output ON during clean operation in case of stop
by remote controller
The air conditioner stops (including fire alarm such as remote
monitor system) while setup of [ON/OFF] operation prohibited
(Central 1, 2) is performed from the central controller side.
0000: Valid (Clean operation)
0001: Invalid (No clean operation)
0000: Invalid (Impossible) 0001: Valid (Possible)
0000: Invalid (Impossible) 0001: Valid (Possible)
0000: Invalid (Self clean operation is not carried out.)
0015: Valid (Self clean operation is practiced with 350 rpm.)
0000: Display 0001: No display
0000: None
0001: Exist
At shipment from factory
0002: 1.0 h
0075: 75%
0000: None
0000: Valid
0001: Valid (Possible)
0000: Invalid (Impossible)
0000: Invalid
0000: Display
0000: None
SVM-13050.indb 68SVM-13050.indb 68 7/12/13 11:25 AM7/12/13 11:25 AM
To Next Page
Loading...
