Item Operation flow and applicable data, etc. Description
− 37 −
FILE NO. SVM-13035
12. Remote
Controller-A or
B selection
1. Purpose
This operation is to operate only
one indoor unit using one remote
controller.
2. Description
When operating one indoor unit in
a situation where two indoor units
have been installed in the same
room or nearby rooms, this
operation prevents the remote
controller signal from being
received simultaneously by both
units, thus preventing both units
from operating.
3. Operation
The indoor unit on which the
remote controller selection has
been set to B receives the signal of
the remote controller also set to B.
(At the factory the remote controller
selection is set to A on all the
indoor units.
There is no A setting display.)
Setting the remote controller
To separate using of remote controller for each indoor
unit in case of 2 air conditioner are installed nearly.
Remote Control B Setup.
1. Press [RESET] button on the indoor unit to turn the
air
conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold [CHECK] button on the Remote Control
by the tip of the pencil. "00" will be shown on
4. Press [MODE] during pushing [CHECK]. "B"
will show on the display and "00" will disappear
and the air conditioner will turn OFF. The Remote
NOTE : 1. Repeat above step to reset Remote
Control to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
Control B is memorized [Picture ).
factory is A.
the display (Picture ).
1
2
13. Short Timer In the normal condition, after switching one
circuit breaker, 3-minute delay time for
compressor and 1 hour for plasma air purifier
are set for the maintenance of the unit.
Purpose
To start the unit immediately for the purpose
of testing, trial...etc, short timer can be
used maintenance of the unit.
Short Timer Setting
Q
Push [ ] button to turn the unit OFF.
R
Set the operation mode on the remote
controller without sending the signal to
the unit.
S
Use the tip of the pencil to push the
[CHK] button and hold, “00” will show
on display then push [SET] button
to make "00" disappear.
T
Push [ ] button to turn the unit ON.
U
When short timer is activated, all setting
on the remote controller operates
immediately, besides, all indicatiors
on front panel turn ON continuously
for 3 seconds.
12
2
1
To Next Page
Loading...
