Carrier 42UQV050M - Remote Controller Operations (Continued); DRY, Hi-POWER, ECO, Temporary, Timer Operations

FILE NO. SVM-13035
5. ECO OPERATION
To automatically control room to save energy (except in DRY and FAN ONLY mode)
Press : Start and stop the operation.
Note: Cooling operation; the set temperature will increase automatically 1 degree/hour for 2 hours
(maximum 2 degrees increase). For heating operation the set temperature will decrease.
6. TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop
without using the remote control.
• Operation mode is set on AUTOMATIC
operation, preset temperature is 24°C
and fan operation is automatic speed.
7. TIMER OPERATION
Setting the ON Timer Setting the OFF Timer
Press : Set the desired ON timer. Press : Set the desired OFF timer.
Press
: Set the timer.
Press : Set the timer.
: Cancel the time
Press
: Set the ON timer
.
Press .
Press : Set the OFF timer .
Press button during the ( or )
mark flashing.
1
1
2
3
2
3
4
Daily timer allows the user to set both the ON & OFF timers and will be activated on a daily basis.
Setting Daily Timer
• During the daily timer is activation, both arrows are indicated.
( or )
: Cancel the timer.
Note:
• Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
4. Hi-POWER OPERATION
To automatically control room temperature and airflow for faster cooling or heating
Press : Start and stop the operation.
operation (except in DRY and FAN ONLY mode)
3. DRY OPERATION
For dehumidification a moderate cooling perfermance is controlled automatically.
1. Press : Select Dry .
2. Press : Set the desired temperature.
Set the timer when the air conditioner is operating.
Press
Press
RESET
RESET button
– 43 –