115
APPENDIX D: SystemVut Controller CCN Tables
Service Config Tables (cont)
TABLE DISPLAY NAME VALUES UNITS POINT NAME WRITE STA TUS
ALM_CFG (cont)
General Status Alerts Yes/No GENS_AL Yes
Refrig Circuit Alerts Ye s/No CKT_AL Yes
Compressor Alerts Yes/No COMP_AL Yes
Heating Failure Alerts Yes/No HEAT_AL Ye s
Indoor Fan Alerts Yes/No FAN_AL Yes
Relay On Active Faults Yes/No FAULT_AL Ye s
ZSENSCFG
Zone Sensor 1 Address 0 to 255 ZSADDR1 255
Zone Sensor 2 Address 0 to 255 ZSADDR2 255
Zone sensor 3 address 0 to 255 ZSADDR3 255
Zone sensor 4 address 0 to 255 ZSADDR4 255
Zone sensor 5 address 0 to 255 ZSADDR5 255
ZS Force Unoccup enable Yes/No ZSFUNEN No
ZS Force unocc wt delay Yes/No ZSFUNWT No
Zone sensor poll rate 1 to 100 sec ZSPOLLRT 5
ZS TLO Cont Enable Yes/No ZSTLOEN No
ZS TLO set during occ Yes/No ZSTLSOC No
Zone sensor UI Mode 1 = Dual Offsets ZSUIM 1 = Dual Offsets
Zone sensor unit 0 = degrees F ZSUNIT 0 = degrees F
TOUCHCFG
System Touch Device Inst 0 to 4194303 DEVST 160099
System Touch Poll Rate 10 to 60 POLLST 10
System Touch AI for SPT 0 to 9999 AISTSPT 1
System Touch AI for SPRH 0 to 9999 AISTSPRH 4
TRIM
OAT Sensor Trim Offset --- 10 t o 10 °F OAT_TRIM 0
RAT Sensor Trim Offset --- 30 to 30 °F RAT_TRIM 0
FST Sensor Trim Offset --- 10 to 10 °F FST_TRIM 0
SPT Sensor Trim Offset --- 30 to 30 °F SPT_TRIM 0
SPTO Sensor Offset Trim --- 1 t o 1 °F SPTOTRIM 0
SPRH Sensor Trim Offset --- 15 to 15 % SPRHTRIM 0
IAQ sensor trim offset --- 200 to 200 PPM IAQ_TRIM 0
OAQ Sensor Trim Offset --- 200 to 200 PPM OAQ_TRIM 0
OARH Sensor Trim Offset --- 15 to 15 % OARHTRIM 0
RARH Sensor Trim Offset --- 15 to 15 % RARHTRIM 0
Cir.A SSP Sensor Trim --- 50 to 50 PSI SSPATRIM 0
Cir.A SDP Sensor Trim --- 50 t o 50 PSI SDP ATRIM 0
Econ Fdback Trim Offset --- 15 to 15 % EC1DTRIM 0
OACFM sensor trim offset --- 200 to 200 CFM OCFMTRIM 0
DISPLAY
Metric Display Ye s/No DISPUNIT No
Display Language Select 0=English,
1=Spanish,
2=French,
3=Portuguese
LANGUAGE 0=English
LCD Contrast Adjustment 1to10 LCD_CONT 5
User Password Protection Enable/Disable PASS_EBL Enable
User Password 0 to 9999 PASSWORD 1111
To Next Page
Loading...
