14
Installation on the roof
The following picture shows the roofcurb elements that enable
adjusting and levelling it. They are supplied assembled on the
roofcurb. They must be disassembled to make adjustment when
the steel pan is mounted.
The roofcurb will be supported on some joists placed for this
purpose in the roof (check the location of ducts for the air supply
and air return).
Joists
Handling
For transport and lifting up to the roof using a crane, a rocker arm
as well as approved slings, both suitable for the dimensions and
weight of the roofcurb, must be used. These slings will be hooked
on the lifting grips fi tted to the roofcurb.
Lifting grips
Reinforcing angle piecesAdjusting angle pieces
Check that the grips are perfectly
screwed in before attaching the slings.
After the placing of the roofcurb, it is
recommended to remove the grips as
they can be a hindrance for sealing
upsweep. Each grip is fixed to the
crossbar using 4 M4 screws. Put the
grips back in case of transport.
Note: All roofcurb are supplied with a return safety grille intended
for plenum installations. For installations with ducted return, the
grille must be removed prior to place the machine on the roofcurb.
Safety grille
7 - POSITIONING AND INSTALLATION
After the above operation remove the four reinforcing angle pieces
to position them in the roofcurb. Attach them to the roofcurb with
two screws without screwing them completely.
Reinforcing angle piece
Tightening screws
JoistReinforcing angle piece
Check that the adjustable angle pieces are in the correct position
on the joists before the roofcurb is fi tted. Next, provisionally attach
the adjustable angle pieces to the joists with one or two self-tapping
screws per angle part.
100
50
Joist
Self-tapping screw
or spot weld
Tightening bolts
with blind rivet
nuts (M10)
Adjustable
angle piece
Slide the four adjustable angle pieces below the steel pan on top
of the joists.
The adjustable angle pieces are fi xed to the joists using self-
tapping screws or electric spot welding.
A
B
A
B
Joists
50FC Roofcurb
Standard With burner
A (mm) B (mm) A (mm) B (mm)
100 to 120 3.569 1.998 3.572 1.993
130 to 170 3.973 1.998 3.978 1.993
180 to 220 5.053 1.998 5.058 1.993
250 to 280 6.096 1.998 6.102 1.993
Lifting grip
Sling hook
Lay the roofcurb. The reinforcing angles prevent the roofcurb from
moving. The roofcurb should slide into the 4 adjusting angle pieces.
To Next Page
Loading...
