Carrier 50HS - Page 7

SIZES 042-060 WITHOUT BASE RAIL
UNIT
ELECTRICAL
CHARACTERISTICS
UNIT WT CORNER WT (Lb/Kg)
Lb Kg A B C D
50HS042,048 208/230-1-60, 208/230-3-60, 460-3-60 359 163 89/40 81/37 113/51 76/35
50HS060 208/230-1-60, 208/230-3-60, 460-3-60 373 170 92/42 85/39 116/53 80/36
UNIT
CENTER OF GRAVITY (in./mm)
XYZ
50HS042,048 19.7/500 20.5/522 15.0/381
50HS060 19.7/499 20.6/523 15.0/381
REQ’D CLEARANCES FOR SERVICING — in. (mm)
Indoor Coil Access Side ...................30(762)
Control Box Access Side ..................30(762)
(Except for NEC requirements)
Unit Top ...........................36(914)
Side Opposite Ducts ....................30(762)
REQ’D CLEARANCES TO COMBUSTIBLE MAT’L — in. (mm)
Unit Top ...............................0
Duct Side of Unit ..........................0
Side Opposite Ducts ........................0
Bottom of Unit ...........................0
Vertical Discharge, First 12 in. (305) of Supply Duct .....1(25)
NEC REQ’D CLEARANCES — in. (mm)
Between Units, Control Box Side .............42(1067)
Unit and Ungrounded Surfaces, Control Box Side ......36(914)
Unit and Block or Concrete Walls and Other
Grounded Surfaces, Control Box Side ..........42(1067)
LEGEND
CG — Center of Gravity
MAT’L — Material
NEC — National Electrical Code
REQ’D — Required
NOTES:
1. Clearances must be maintained to pre-
vent recirculation of air from outdoor-fan
discharge.
2. Dimensions in ( ) are in mm.
7