9
fi g. 6.4 fi g. 6.5
The following steps must be followed:
● Skids:
- Remove the 4 skids (M6 screws).
- Disassemble the inner part of each skid (Allen M4 screws)
(see fi gures 6.4 and 6.5).
- Reattach the skids to the crossbars (M6 screws) (see fi gure
6.3).
fi g. 6.3
6 - HANDLING
Important: Before starting the
module installation, remove the
transport feet fi xed by M6 screws
(see fi gure 6.9).
● Guides:
- Remove the guides (M6 screws).
- Disassemble the parts used to insert the forks (M8 screws)
(see fi gure 6.6).
fi g. 6.6
- Disassemble the inner parts of the guides (M4 screws) (see
fi gures 6.7 and 6.8).
- Reattach the skids to the crossbars (M6 screws per skid)
(see fi gure 6.3).
fi g. 6.7 fi g. 6.8
Important: Before starting the box installation, remove the
transport feet fi xed by M6 screws (see fi gure 6.9).
fi g. 6.9
Transport foot
fi g. 6.8
Indoor module (Split version)
The crossbeams of the indoor module are equipped with support
feet for transport with a forklift. These feet make it easy to
accommodate the forks of the forklift truck.
The recommended length for the forks will be bigger than the
unit width, so that the entire weight-bearing structure of the unit
can be supported on the forklift truck.
The standards and recommendations of the forklift truck must
also be respected with regard to the maximum load, inclination
of the fork carriage, elevation of the load for transport, and the
maximum speed.
Transport foot
Mixing box (CS assembly)
The same guidelines for transporting the mixing box apply as
for the indoor module.
Before dragging the module, the skids and guides must be
disassembled, and a series of operations must be carried out
to reattach them to the crossbars. They should be reattached
as shown in fi gure 6.3.
To Next Page
Loading...
