5. CARE AND MAINTENANCE
7GB-11
DISCONNECT from power source BEFORE attempting to clean or service!
Use a soft damp cloth when cleaning the grille, casing and remote control.
Always contact a qualified service personnel to carry out repair or any
non-user serviceable maintenance, such as deep-cleaning, lubricate and
function check of critical component.
CAUTION
General Cleaning
Cleaning The Air Filter
Use a soft damp cloth when cleaning the grille, casing and remote controller.
- No chemicals e.g. detergents, solvents, abrasive polish, etc.
- No heat (over 40
°C)
To maintain the good performance, regularly inspect air filters and clean them if required.
Remove the Upper filter
- Pull open the grille
- Take out the filter
Remove the Lower filter
- Unscrew the grille
- Take out the filter
NOTE:
The air-in side should face up when using vacuum cleaner.
The air-in side should face down when using water.
Clean the air filter
Vacuum cleaner or pure water may be used to clean the air filter. If the dust accumulation is too heavy , please use soft brush and
mild detergent to clean it and dry out in cool place. Re-install the air filter after ensuring filter is thoroughly dry.
Storage Preparation [long idle periods]
1. Clean the air filters
2. Make sure the unit is completely drained of water and dry.
In humid or damp climates, operate in Fan only mode until
the unit has dried out.
3. Turn the air conditioner off with the remote and remove the
batteries.
4. Disconnect from the power source. Wrap the power cord
around the mains cord brackets and plug the plug into the
socket at the back of unit.
5. Properly dispose the accessories, e.g. exhaust hose,
window slider kit, etc.
Re-use After Storge
1. Check if anything block the air inlet and outlet.
2. Clean the air filters
3. Check the wires if any damaged or proper grounded.
4. Re-install the accessories.
5. Reconnect to the power source
6. Reinstall the batteries into the remote controller and turn
the unit on.
To Next Page
Loading...
