Carrier 58MVP - Page 3

FURNACE COMPONENTS
[_ Cornbnstion-air intake connection to ensure contami-
U1
nant-fiee air (right or left side).
Burner sight glass for viewing burner flalne.
Burner assembly (inside). Operates with energy-saving
inshot burners and hot surt_ce igniter for safe,
dependable heating.
Redundant gas valve. Safe and efficient. Features 1 gas
control with 2 internal shutoff valves. Valve appearance
varies with furnace model.
Vent outlet. Uses PVC pipe to carry flue gas fiom the fnr-
nace's combustion system (right or left side).
Inducer motor. Pulls hot flue gases through the heat ex-
changers, maintaining negative pressure for added safety.
Blower access panel safety interlock switch.
Air filter and retainer.
Condensate &ain connection. Collects moisture con-
densed fiom burned gases for disposal into holne drain
system. (Location in fnrnace varies.)
Heavy-duty blower. Circulates air across the heat ex-
changers to transfer heat into the home.
Secondary condensing heat exchanger (inside). Wrings
out more heat through condensation. Constructed with
polypropylene-laminated steel to ensure durability.
Primary serpentine heat exchanger (inside). Stretches fuel
dollars with the S-shaped heat-flow design. Solid con-
struction of corrosion-resistant aluminized steel means re-
liability.
Furnace control board.
3-amp fuse provides electrical and component protection.
Light emitting diode (LED) on fnrnace control board.
Code light is for diagnosing furnace operation and service
requirements.
Pressure switch(es) ensure adequate flow of flue gas
through furnace and out vent systeln.
Rollout switch (manual reset) to prevent overtemperature.
Junction box for 115-v electrical power supply. (May be
located on right or left side)
Transformer (24v) behind furnace control board pro-
vides low-voltage power to fnrnace control board and
thermostat.
2 ©
11
16
9
10
17
3
12
18
14
15
13
7
19
MODELS 58MXA, 58MCA, AND 58MTA
FURNACES (UPFLOW POSITION)
17
llJ
15
14
13
7
19
l0
3
MODEL 58MVP
FURNACE (UPFLOW POSITION)
4