126
Fig. 93 — Single Slope Condensate Drain — Apply Gasket
BAFFLE, TOP
CHANNEL, HAT
COIL FRAMES
BAFFLE, RIGHT
ANGLE
ATTACHED TO COILS
BOTH SIDES
BOTTOM BAFFLE
APPLY FLUSH TO THIS EDGE
GASKET, ADHESIVE
BAFFLE, BOTTOM
IMPORTANT: ADHESIVE GASKET MUST BE
APPLIED TO THE FULL LENGTH OF THE BOTTOM
BAFFLE MATING FLANGE TO CREATE SEAL BETWEEN
THE COIL SIDE CASING AND THE BAFFLE.
SEE ILLUSTRATION BELOW.
BAFFLE, CENTER
PAN, CONDENSAT E
CENTERED WITHIN SECTION
BAFFLE, LEFT
CHANNEL, HAT
Fig. 94 — Double Slope Condensate Drain — Apply Gasket
a39-2988ef
To Next Page
Loading...
