34
CONTROLLER SETTINGS
The controller settings are accessible through the System Config
Menu (Service password access required). See Fig. 61 and 62.
Fig. 61 — System Configuration Menu
Fig. 62 — Network Menu
Unit IP Address
On the System Config Menu screen, press Network Configuration
to display the network parameters. See Fig. 63.
NOTE: You must request an IP address, the subnet mask, and the
default gateway from the system administrator before connecting
the unit to the local Ethernet network.
To change IP address manually, select the applicable ethernet con-
figuration port from the Network Menu. See Fig. 63.
Fig. 63 — Ethernet Configuration
Enter the new address, Subnet Mask, and Default Gateway and
validate it by pressing OK and Save. Return to the Network screen
and enter the subnet mask and default gateway using the same
method. Then return to the application and save the changes.
DNS Configuration
Select DNS Configuration from the Network Menu and change
the DNS IP to desired value and then select OK and then Apply.
Status will be updated accordingly. See Fig. 64.
Fig. 64 — DNS Configuration
CCN Configuration
To modify the CCN configuration, select CCN Protocol Menu
from the System Configuration Menu. The PIC6 CCN address,
bus number and baud rate and be adjusted as per requirements.
See Fig. 65.
Fig. 65 — Control Identification Screen
To Next Page
Loading...
