AQUASMART remote control
GB - 4
Fan speed selection
(button C)
The fan speed can be selected by pressing button .
Symbol on display
Low speed
(for night operation)
Medium speed
High speed
(to reach desired condition)
Automatic
(Fan speed will automatically be controlled for optimum
comfort).
When this function is activated, the dotted symbols light
up.
Addressing selection
In a system with several interconnected units it is possible to assign
an address to each single unit. Address selection allows several
units to be individually controlled with one remote control and
avoids possible interference with other units.
It is possible to select up to 12 addresses maximum.
For the selection proceed as follows:
• Press buttons
simultaneously for 5 seconds to enter the
pre-set address selection configuration menu.
Example 1
• Press button or to increase or decrease the selected address.
• To confirm the selection, press button
.
• The remote control exits from the configuration and returns to the
previous operating mode, if no button is pressed for 30 seconds.
Remote control configuration
1) ADDRESSING SELECTION
Address selection allows correct selection of the unit type to which
the remote control is connected.
Access to the “ADDRESS CONFIGURATION” mode:
• Simultaneously press and hold down buttons
(guide vanes)
and
reset (this button is under the remote control cover), until
“-1” appears in the display.
• Press button
(guide vanes) and then buttons or to
increase or decrease the number of selected address (1-12).
The default value is 1.
• To confirm the selection, press button
.
2) UNIT TYPE SELECTION
This function allows the selection of the correct unit type to be used
with the remote control.
Access to the “UNIT CONFIGURATION” mode:
• Simultaneously press and hold down buttons
(guide vanes)
and
reset (this button is under the remote control cover), until
“-1” appears in the display.
• Press button
to change the selection and go to the next one.
The display will show “-2”
• Press button
(symbol “--” will appear in the display which
indicates that the first value in the display is unidentified) and then
press button
to select the unit type (see table).
Selection number Unit type
1 Hi-Wall (016 - 020 - 028)
2 (not available)
3 Cassette (all)
4 (not available)
5 (not available)
• To confirm the selection press button
.
• The remote control will exit the menu “Unit type selection”, and will
return to the previous operating mode, if 30 seconds have elapsed
and no button was pushed.
3) WINDOW CONTACT SELECTION
It is possible to configure the window contact in the NO condition
(normally open) or the NC condition (normally closed).
To carry out the configuration proceed as follows:
• Simultaneously press and keep pressed buttons
(louvres) and
(reset (the latter is on the remote control cover) for
approximately 5 seconds.
• Press button
until “-4” appears in the display.
• Press button
(louvres) to select the mode.
Use and configuration of the remote control
To Next Page
Loading...
