4
8. Inspect all electrical connections. Be sure connections are
clean and tight at the terminals.
9. Check unit controls. If Complete C, or Deluxe D, verify field
provided thermostat or DDC control is available. If WSHP
Open, verify proper sensor has been provided and a commis-
sioning interface will be available.
10. 50HQP Only - Locate the hanging bracket kit located in the
compressor compartment.
11. 50HQP Only - For units with the SAV
TM
or single speed
VFD option, locate the VFD (ships in control box section or
on the pallet with the unit). See Fig. 1 for VFD shipping box
location. If VFD is not found, contact your Carrier sales
representative.
Fig. 1 — Field Installed VFD Shipping Location, 50HQP Units
AIR COIL
COMPRESSORS
ELECTRICAL
CONTROL
BOX
VFD
BOX
BLOWER BLOWER
BLOWER
MOTOR
BLOWER
MOTOR
To Next Page
Loading...
