Mode ..................................... Pg. 3
Mode refers to the type of operation your system is
set up to perform. Mode settings include: OFF, HEAT,
COOL and AUTO. Heat pump systems also include
EMERGENCY HEAT (EHEAT).
Outdoor Temperature ....................... Pg. 4
Your thermostat not only registers the indoor temper-
ature, but it may also be equipped to register and
display the outdoor temperature as well. Press the UP
and DOWN buttons simultaneously to read the out-
door temperature display.
Power Outage .............................. Pg. 7
Complete loss of electricity. Your thermostat has an
internal power source that will allow it to maintain
your desired temperature settings indefinitely. This
function does not require batteries.
Reset FiIter ................................ Pg. 4
The reset filter function turns off the SERVICE
FILTER indi cator and restarls the system. Press the
RESET FILTER bu tlon after you've cleaned and
replaced the system's air filter.
Set Poir_s ................................. Pg. 2
The heatin 9 and coolin 9 temperature set points you
wish the system to maintain and have entered into
the thermostat. The actual room temperature will
automatically be displayed, but you can check the
desired temperature by pressin 9 either the UP or
DOWN bu tlon. While the SET TEMP indi cator is lit,
press the MODE button to display the desired tem-
perature set points for the other mode.
Temperature Sensor ........................ Pg. 7
The temperature sensor measures the current indoor
or outdoor temperatures which are displayed on the
thermostat.
Up and Down Buttons ....................... Pg. 1
These buttons are used to set your desired
temperature set points.
10 11
To Next Page
Loading...
