3-1 62-02575-07
SECTION 3
DATAVIEW PROGRAM INSTRUCTIONS
NOTE
The following is a copy of the software program at time of printing. If loading only one program
(12--00413 reciprocating unit interrogation or 12--00528 scroll unit interrogation program) the pro-
gram disc instructions may be followed as written. If loading both programs on the same computer,
different resident directories must be created Where these differences exist, annotation has been add-
ed to the text provided herein.
Refer to the manual Table of Contents for a listing of the following Topics and the material provided
under the topic heading.
TOPIC 1 SYSTEM REQUIREMENTS
This section describes the PC and printer system requirements for the DOS DataView interrogator program.
Desktop Computer
1. MS--DOS compatible computer with an 80186 or higher microprocessor.
2. A hard--disk system ( Or hard--disk emulation with electronic memory).
3. MS--DOS version 3.3 or higher.
4. A minimum of 640KB free System Memory (RAM).
5. A minimum of 3MB free hard--disk space.
6. One 3.5-- inch disk drive. If the system has one diskette drive it will have a drive designator of A. If the system is
configured with two diskette drives the second drive will be designated as B.
7. One Serial Port not dedicated to a FAX--Modem.
8. One of the following ports available for a printing;
Serial port
Parallel port
Network Connection
9. Serial to serial, serial to parallel, or parallel to parallel printer cable.
HP Palmtop Computer
1. MS--DOS compatible computer with an 80186 or higher microprocessor.
2. MS--DOS version 3.3 or higher.
3. A minimum of 640KB free System Memory (RAM).
4. A minimum of 3MB ROM free space available.
5. One RS--232 serial port.
6. Connectivity Pack to transfer/receive files from a desktop computer to/from the HP Palmtop computer.
7. Serial to serial or serial to parallel printer cable.
Pen--Based Computer
1. MS--DOS compatible computer with an 80186 or higher microprocessor.
2. MS--DOS version 3.3 or higher.
3. A minimum of 640KB free System Memory (RAM).
4. A minimum of 3MB ROM free space available.
5. Optional 3.5 floppy disk drive.
6. One RS--232 serial port.
7. Optional parallel port.
8. Serial to serial, serial to parallel, or parallel to parallel printer cable.
To Next Page
Loading...
