( 10 )
USE OF REMOTE CONTROL (Cont.)
HEAT MODE
START
1. Press MODE button to select HEAT mode
on the remote control display.
2. Press TEMP buttons or to select the set
temperature on the remote control display.
Set desired temp. between 17°C and 30°C.
3. Press FAN SPEED button to select
the desired fan speed appears
on the remote control display.
4. Press ON/OFF button to start
the air conditioner.
ON symbol appears on the
remote control display.
OPERATION led will illuminate
on the display panel of indoor unit.
HEAT mode starts after approximately 3 minutes
and Plasma operates for refeshing air, removing
smoke and dust particles. Plasma gives an
immediate sensation of energy and well-being.
STOP
If you want to stop the air conditioner,
Press ON/OFF button again.
NOTES
• If the room temperature is lower than
the selected temperature, the system will start HEAT mode.
• If the room temperature is equal to or higher than
the selected temperature, the system will stop HEAT mode.
• If you use AUTO fan speed with HEAT mode, the fan speed
changes automatically to low or medium or high speed
based on the temperature difference between setting
temperature and room temperature.
4
2
2
1
3
To Next Page
Loading...
