Carrier Infinity SYSTXCCUID01-B

To Next Page

SYSTXCCUID01-- B

Infinityt Control

Installation Instructions

HOLD

COOL

HEAT

OFF

A03149

Fig. 1 -- Infinityt Control

NOTE: Read the entire instruction manual before starting the

installation.

TABLE OF CONTENTS

PAGE

SAFETY CONSIDERATIONS 1.........................

INTRODUCTION 2...................................

INSTALLATION AND START-- UP OVERVIEW 2..........

INSTALLATION 2....................................

INSTALLING INFINITY CONTROL 4....................

INITIAL POWER--UP 6................................

QUICK START 7.....................................

INSTALL / SERVICE MENUS 8.........................

EQUIPMENT SUMMARY MENU 8......................

INSTALL MENU 8....................................

SETUP MENU 9......................................

CHECKOUT MENUS 12...............................

SERVICE MENUS 13..................................

OPERATIONAL INFORMATION 14.....................

TROUBLESHOOTING 16..............................

SYSTEM MALFUNCTION SCREEN 17..................

SAFETY CONSIDERATIONS

Read and follow manufacturer instructions carefully. Follow all

local electrical codes during installation. All wiring must conform

to local and national electrical codes. Improper wiring or

installation may damage the Infinity System. Recognize safety

information. This is the safety--alert symbol

. When you see

this symbol on the equipment and in the instruction manual, be

alert to the potential for personal injury. Understand the signal

words DANGER, WARNING, and CAUTION.

These words are u sed with the safety-- alert symbol. DANGER

identifies the most serious hazards, which will result in severe

personal injury or death. WARNING signifies a hazard, which

could result in personal injury or death. CAUTION is used to

identify unsafe practices, which may result in minor personal

injury or product and property damage. NOTE is used to highlight

suggestions which will result in enhanced installation, reliability , or

operation.

Main Page

Need help?

Do you have a question about the Carrier Infinity SYSTXCCUID01-B and is the answer not in the manual?

Summary

Safety Considerations

Installing Infinity Control

Initial Power-Up

Power Up Sequence

Describes the sequence of events during the system's initial power-up.

Install; Service Menus

Setup Menu

Checkout Procedures

Equipment Checkout

Tests operation of furnace, heat pump, cooling, humidifier, and ventilator.

Service and Status

Furnace and System Status

Displays operating parameters for furnace and system status.

System Events and History

Troubleshooting

Common Issues and Solutions

Addresses power issues, unit not found, and re-entering start-up.

System Malfunction Screen

Component Malfunction Codes