36
From the QR code reader
there are four wires, power
and communication to be
connected at the readers
terminal blocks.
Technical data QR code module
Note that the connected LNL-R50360-04TB (without keypad) and
LNL-R50365-04TB (with Keypad) reader must be running on Firmware
3.82.09 or higher to use the QR module as an accessory. Older firmware
versions of LNL-R50360-04TB (without keypad) and LNL-R50365-04TB
(with Keypad readers will not detect the QR code reader. Settings can
be done with LenelS2 Reader Tool LNL-R50000-tool version 6.5.0.7 or
higher.
Green wire D+/RX
White wire D-/TX
Red wire DC+
Black wire GND
Connection cable QR code module
36
From the QR code reader
there are four wires, power
and communication to be
connected at the readers
terminal blocks.
Technical data QR code module
Note that the connected LNL-R50 x (5-6) x-xxxx reader must be
running on Firmware 3.82.09 or higher to use the QR module as an
accessory. Older firmware versions of LNL-R50x (5-6) x-xxxx readers
will not detect the QR code reader. Settings can be done with LenelS2
Reader Tool LNL-R50000-tool version 6.5.0.7 or higher.
Green wire D+/RX
White wire D-/TX
Red wire DC+
Black wire GND
Connection cable QR code module
Sensor resolution 640 horizontal x 480 vertical
Illumination White LED
Aiming None
Symbologies
QR code, micro QR and PDF417
Code 128, Code 39, Codabar, Interleaved 2 of 5, ITF-6, ITF-14
ISBN, Code 93, UCC/EAN-128, GS1 Databar, Matrix 2 of 5,
Code 11, Industrial 2 of 5, Plessey, MSI-Plessy
Resolution
>3 mil
Typical depth of field (QR 10 mil) 35 mm to 80 mm
Symbol contrast 25% min.
Scan angel
Roll: 360°, pitch: ±60°, skew ±60°
Field of view Horizontal 42°, vertical 31.5°
Operating voltage 9 to 30 VDC
Power consumption Current draw (Idle mode) 2.3 mA at 12 VDC, 1.2 mA at 24 VDC
Operating temperature -20 to +55°C
Relative humidity 5 to 95% noncondensing
Ambent light 0 to 100,000 lx
To Next Page
Loading...