5
Power Consumption
Power Consumption LED-Brightness Current draw (idle) Current draw (peak)
Model: LenelS2 Readers - 5000 Series LED-Bar Backlight 12 VDC 24 VDC 12 VDC 24 VDC
Standard 13.56 MHz with keypad Low Low 50 mA 40 mA 147 mA 99 mA
Standard 13.56 MHz with keypad Medium Low 50 mA 40 mA 184 mA 116 mA
Standard 13.56 MHz without keypad Low Low 50 mA 40 mA 135 mA 94 mA
Standard 13.56 MHz without keypad Medium Low 50 mA 40 mA 172 mA 111 mA
Standard 13.56 MHz/125 kHz with keypad Low Low 90 mA 60 mA 187 mA 119 mA
Standard 13.56 MHz/125 kHz with keypad Medium Low 90 mA 60 mA 224 mA 136 mA
Standard 13.56 MHz/125 kHz without keypad Low Low 90 mA 60 mA 175 mA 114 mA
Standard 13.56 MHz/125 kHz without keypad Medium Low 90 mA 60 mA 212 mA 131 mA
Standard 13.56 MHz/125 kHz SF/2F version with keypad Low Low 90 mA 45 mA 163 mA 91 mA
Standard 13.56 MHz/125 kHz SF/2F version with keypad Medium Low 90 mA 45 mA 181 mA 94 mA
Standard 13.56 MHz/125 kHz SF/2F version without
keypad
Low Low 90 mA 45 mA 159 mA 89 mA
Standard 13.56 MHz/125 kHz SF/2F version without
keypad
Medium Low 90 mA 45 mA 177 mA 92 mA
Slimline 13.56 MHz with keypad Low Low 50 mA 40 mA 164 mA 108 mA
Slimline 13.56 MHz with keypad Medium Low 50 mA 40 mA 217 mA 135 mA
Slimline 13.56 MHz without keypad Low Low 50 mA 40 mA 152 mA 103 mA
Slimline 13.56 MHz without keypad Medium Low 50 mA 40 mA 205 mA 130 mA
Slimline Economy 13.56 MHz without keypad Low Low 35 mA N/A 92 mA N/A
Slimline Economy 13.56 MHz without keypad Medium Low 35 mA N/A 114 mA N/A
The above values are excluding heater consumption which is variable and depending on configu-
ration settings. Default value is 220 mA at 12 VDC but can be configured in 20 mA intervals
from minimum 120 mA to maximum 300 mA. When the heater is set in automatic mode, the
heater will be activated when the internal temperature of the reader is below +1°C, the heater will
automatically deactivate when the internal temperature exceeds +5°C.
Depending on the heater consumption setting the time it will take for the reader to exceed +5°C
will vary- a higher power consumption setting will reduce the time required to heat
the reader.
Current draw (idle) is defined as reader connected to power, no LED’s lit, buzzer is
not sounding and no reading of credential or key pressing is processed by the reader.
Current draw (peak) is defined as reader powered with both backlight and LED frame lit (Yel-
low), buzzer is sounding and reader is reading a credential while simultaneously a key pressing is
processed.
To Next Page
Loading...