Carrier MPPDA-09CRN7-QB6G1 - Installation; Choosing The Right Location

Accessories
North America
Check your window size and choose the fit window slider.
Part Description
1 pc 2 pc
1 pc 2 pc
1 pc 2 pc
1 pc
1 pc
1 pc
2 pc
2 pc
1 pc
2 pc
1 pc
1 pc
1 pc
1 pc
1 pc
1 pc
1 set
1 set
Unit Adaptor
Window Slider Adaptor
Window Slider A
Window Slider A
Window Slider B
Window Slider C(optional)
Exhaust Hose
Bolt
Foam Seal A (Adhesive)
Foam Seal B (Adhesive)
Foam Seal C (Non-adhesive)
Security Bracket and Screw
Drain Hose
Drain Hose Adaptor(only for
heat pump mode)
Quantity
single-exhaust
unit(MODEL A)
double-exhaust
unit(MODEL B)
Part Description Quantity
2 pc
1 pc
Bolt(optional)
Remote Controller
and Battery
ON/OF F
TEMP
SHOR T
CU T
TIME R ON
TIME R OFF
MODE
FAN
SLE E P
SWIN G
LED
NOTE: Items with are optional. Slight variations in design may occur.
*
Foam Seal A (Adhesive)(optional)
Foam Seal B (Adhesive)(optional)
Foam Seal C (Non-adhesive) (optional)
*
*
*
*
*
Power Cord Buckle
Installation
Choosing The Right Location
Recommend Installation
Your installation location should meet the following requirements:
-Make sure that you install your unit on an even surface to
minimize noise and vibration.
-The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
-The unit should be located at least 30cm (12”) from the nearest
wall to ensure proper air conditioning.
-DO NOT cover the Intakes, Outlets or Remote Signal Receptor
of the unit, as this could cause damage to the unit.
NOTE:
All the illustrations in the manual are for explanation
purpose only. Your machine may be slightly different.
The actual shape shall prevail.
The unit can be controlled by the unit control panel
alone or with the remote controller. This manual does
not include Remote Controller Operations, see the
<<Remote Controll Illustration>> packed with the unit
for details.
When there are wide differences between
“INSTRUCTION MANUAL” and “Remote controll
Illustration” on function description, the description on
“INSTRUCTION MANUAL ” shall prevail.
50cm
19.7inch
Tools Needed
-Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors; -Saw (optional, to shorten window
adaptor for narrow windows)
9