Carrier MPPDA-09CRN7-QB6G1 - Installation; Hung Window or Sliding Window Installation; Wall Installation

Installation
11
3.Cut the non-adhesive foam seal C strip to match the width of the
window. Insert the seal between the glass and the window frame to
prevent air and insects from getting into the room.
4.If desired, install the security bracket with 2 screws as shown.
2 Screws
Security Bracket
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
Foam seal C
(Non-adhesive type)
Foam seal C
(Non-adhesive type)
2 Screws
Security
Bracket
Type 2: Wall Installation(optional)
1.Cut a 125mm (4.9inch) hole into the wall for the Wall
Exhaust Adaptor B. 2.Secure the Wall Exhaust Adaptor B
to the wall using the four Anchors and Screws provided in
the kit. 3.Connect the Exhaust Hose Assembly(with Wall
Exhaust Adaptor A) to the Wall Exhaust Adaptor B.
Note: Cover the hole using the
adaptor cap when not in use.
Note: To ensure proper function, DO NOT overextend or
bend the hose. Make sure that there is no obstacle around
the air outlet of the exhaust hose (in the range of 500mm)
in order to the exhaust system works properly. All the
illustrations in this manual are for explanation purpose only.
Your air conditioner may be slightly different. The actual
shape shall prevail.
max 120cm or 47 inch
min 30cm or 12 inch
Expansion anchor
position
Adaptor cap
Wall Exhaust
Adaptor B
Note: Once the Exhaust Hose assembly and Adjustable Window Slider
are prepared, choose from one of the following installation methods.
1.Cut the adhesive foam seal A and B strips to the
proper lengths, and attach them to the window sash
and frame as shown.
or
or
or
or
or
or
MODEL A
MODEL B
2.Insert the window slider assembly into the window opening.
Type 1: Hung Window or Sliding Window Installation(optional)
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
VENT CONTROL feature
The Vent Control is located at the back of the air
conditioner. The OPEN position removes stale air
from the room and exhausts it to the outside. Fresh
air is drawn in through normal passages in the home.
When not need to circulate the room air, set Vent
Control to CLOSE position. This function is only
applicable for MODEL B.
C L OS E
OPE N
5.Insert the window slider adaptor into the hole of the window slider.