Carrier THERMIDISTAT CONTROL - Setting the Dehumidification Set Point

SETTING UP THE THERMIDISTAT CONTROL
NOTE: If the indoor humidity level is above
the dehumidify setting, the fan will shut off
for 5 minutes after the air conditioner shuts
off. During this period, a triangle next to
the word ON will flash.
When the AUTO mode is selected, the
fan runs only as needed to maintain
your preferred indoor temperature
settings.
Setting the humidification set point
1
Press the SET HUM button
to enter the humidify mode.
The current indoor humidity (large
number) and humidify set point (small
number) are displayed along with the
humidify indicator (hu).
6