NON-PROGRAMMABLE THERMOSTAT CONFIGURATION RECORD
OWNER/OPERATOR:
HARDWARE CONFIGURATION
Seal hole in wall.
DATE:
THERMOSTAT MODEL NO:
I1. MODE SETTINGS
Mode (Off, Heat, Cool, Auto, Eheat)
Heating Set Point Value
Cooling Set Point Value
Fan (Auto or On)
III. CONFIGURATION OPTIONS
l
2
3
4
5
6
7
8
9
l0
ll-12
13
14
15
16-17
18
19
20
21
Anticipator (1-9: factory default = 3)
Clean Filter Timer (OF or 1-9: facto U default = 2)
Fahrenheit or Celsius (F or C: factory default = F)
Fan On with W/Wl output (OF or ON: factory default = OF)
HP (2-speed)/AC Configuration
Cooling Ix)ckout (OF or ON: factory default = OF)
Zoning Selection (OF or ON: factory default = OF)
Auxiliary Heat Lockout (OF or 5 to 55 F: factory default = OF)
N/A
O (Reversing Valve) (ON with Heat or Cool Selection; default = C) (present on Heat Pump models only).
N/A
Room Temperature Offset (-5 to +5: factory default = 0)
N/A
Enable Auto Mode (OF or ON: factory default = On)
N/A
Backlight Configuration: (ON = Continuous; OF = Backlight with Keypress; Default = OF)
Number of wires (2, 3, 4 or more); Default = 4 or more
N/A
Keypad lockout (OF or ON: Default = OF)
11