Turn the on to the Heating/Air
power
Conditioning system.
@
Press the MODE button repeatedly until
the HEAT icon appears on the display.
Press the up/down buttons until the set
temperature is 10 degrees above room
temperature. The furnace should turn on.
Press the MODE button repeatedly until
the COOL icon appears on the display.
Press the up/down buttons until the set
temperature is 10 degrees below room
temperature. The air conditioner should
turn on. NOTE: Most equipment has a
time delay of 5 minutes between cool
cycles. This feature is defeatable on the
thermostaL Consult the Owner's Manual
under Setup, cycles per hour.
Press the MODE button to OFF. Press
the FAN button to Fan On. The fan
should tum on and run continuously.
Poge9