PREPARATION 2
REMOVE OLD THERMOSTAT 3
INSTALL BACKPLATE & WIRE 4
WIRING DIAGRAMS 5
CALIBRATION 8
TEST OPERATION 9
TROUBLESHOOTING 10
CAUTION Followlnstallotlonlnsln_tion_carefully.
[_SCONNECT POWER TO THE HEATER -
AIRCONDITIONER BEFORE REMOVING
THEOLD THERMOSTATAND INSTALLING
THENEW THERMOSTAT. WARNING
Replacement Components Division _) Carder Corporation 4/01
This device complies with Part 15 of the FCC rules.
Operation is subject to the following2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Fogel
To Next Page
Loading...
Need help?
General
