PREPARATION 2
REMOVE OLD THERMOSTAT 3
WIRE CONNECTIONS 4
WIRING DIAGRAMS 5
CALIBRATION 7
TEST OPERATION 8
TROUBLESHOOTING 9
Follow/nStallation Instructions carefully.
DISCONNECT POWER TO THE HEATER -
AIR CONDITIONER BEFORE REMOVING
1HE OLD "tHERMOSTAT AND INSTALLING
THENEW 11dERMOSTAI_ WARNING
Replacement Component Division © Carrier Corporation 4101
This device complies with Part 15 of the FCC rules.
Operation is subject to the following 2 conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Page 1
To Next Page
Loading...
