Page 1
Table Of Contents
PREPARATION
REMOVE OLD THERMOSTAT
MOUNT WALL PLATE & WIRE
CONNECTIONS & SWITCHES
WIRING DIAGRAMS
CALABRATION
TROUBLESHOOTING
CAUTION
Follow Installation Instructions carefully.
DISCONNECT POWER TO THE HEATER -
AIR CONDITIONER BEFORE REMOVING
THE OLD THERMOSTAT AND INSTALLING
THE NEW THERMOSTAT.
WARNING
2
3
4
5
7
10
11
FCC ID MUH-T10016
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This receiver is designed to operate @
0-70 C
To Next Page
Loading...
