11
Maintenance
Attention
• Repair can only be performed by professional personnel.
• Before touching the connection line, all power supplies should be switched o. Only after switching o the power
supply can the operator clean the air conditioner so as to avoid electric shock or injury.
• When cleaning the lter, make sure to use a stable platform; do not ush the air conditioner with water, or electric
shock might be caused.
Routine Maintainence:
Clean the lter and the air inlet grid.
• Do not dismantle the air indoor unit while running, faults or injury could occur.
• When the air conditioner operates in an environment with too much dust, clean the lter regularly (generally once every two
weeks).
1. Remove the air inlet grid as shown in the gure: press down the two locks on the grid (as shown in Fig. 1) to move it close to the
nearby grid, then gently lift it 45 degrees (as shown in Fig. 2), and then remove the air inlet grid.
2. Dismantle the gauze: press the outer frame of the air inlet grid with the thumb, draw the base angle of the gauze with the
forenger, pull it out so as to make the gauze disengage from the locks, and then dismantle the gauze (as shown in Fig. 3).
1.
Cleaning the Filter
• Cleaning
Clean the air cleaner with a vacuum cleaner or water to remove dust.
If there is too much dust, use the fan or directly spray the special cookware detergent on the air inlet grid, and then clean it with
water after 10 minutes.
(A) remove dust with a vacuum cleaner.
(B) for excessive dust, use a soft-hair brush and a mild detergent to clean.
(C) Allow lter to dry fully before reinstalling.
press down the locks
lock device
lock port
remove air inlet grid
locks
bottom of gauze
lock device
frame of air inlet grid
Fig. 1 Fig. 2 Fig. 3
• Do not clean with hot water of over 50°C to avoid fading or distortion.
• Do not dry on the re, or the cleaner might cause re.
Attention
To Next Page
Loading...
