– 18 –
36-EN35-EN
EN
EN
7
Operating air conditioner without remote
controller (temporary operation)
In the following cases, the air conditioner can be operate without remote controller with temporary operation
button on the signal receiving unit.
• The battery in the remote controller expired.
• A trouble occurred on the remote controller.
• The remote controller has been lost.
1
Start
Push temporary operation button.
• The operation mode is the one last selected.
If you want to change it, turn the power off and
then on, and push the temporary operation
button again.
2 Stop
Push temporary operation button once more.
1
2
6
Self clean mode
This function is provided to dry the inside of the indoor unit by the FAN operation after running the cooling
/ dry / AUTO (cooling) mode to keep the indoor unit clean.
• The self clean time varies with the cooling / dry / Auto (cooling) operation time as follows.
• “ ” is displayed on the remote controller during self clean operation.
• The operation lamp (Orange) lights and (Green) does not light on the signal receiving unit during self clean
operation.
To stop self clean forcibly, press START/STOP button twice in succession.
CAUTION
• The fan continues to run even after START/STOP button is pushed to stop operation in some modes.
This is normal because the self clean mode is in progress.
• The louvers open slightly and are directed horizontally during self clean, and they close when the self clean is
completed.
• The self clean mode (function) cannot clean the room or remove the already existing mold and dust inside the indoor
unit.
• To cancel the self clean function, consult the dealer.
Cooling / dry / Auto (cooling)
self claean time
operation time
No self clean operationLess than 10 minutes
1 hour10 minutes toless than 1 hour
2 hoursMore than 1 hour
1115350277.indd 19 9/27/2018 8:57:14 AM
To Next Page
Loading...
