Carrier ZS Pro - Appendix: Rnet tag numbers

Creating Snap control programs for ZS Sensors
ZS Sensor CARRIER CORPORATION ©2020
Applications Guide All rights reserved
12
4.
Adjust setpoint offset.
Center display=Offset
value. Hide effective
setpoints.
Example of sensor display:
5.
Hospitality mode
Displays only the active effective setpoint or the average of the heating and
cooling setpoints if the mode is auto. The effective setpoint is adjustable.
Editable
Check under
Occupied
or
Unoccupied
to make each setpoint editable on a
ZS Sensor.
Show on
Check the sensor screen(s) that you want
Occupied
,
Unoccupied
and
Effective Setpoints
displayed on.
Home Screen (1)
: Effective Setpoints are displayed on the Home screen in
the following locations:
On the Information or Diagnostics screen, effective setpoints cycle through in
the primary value field and show
EFF
in the Rnet tag field. See Appendix B:
ZS Sensor screen fields (page
37).
Information Screen (2)
: This screen is accessed by pressing the sensor's
button.
Diagnostics Screen (3)
: This screen is accessed by holding the sensor's
button for at least 3 seconds.
NOTE
To enable/disable the setpoint adjustment functionality of specific sensors on the Rnet, double-click the
BACnet Setpoint microblock on the
Logic
page in a running system. On the
Sensor
tab, check/uncheck a sensor's
Allow Setpoint Adjust
checkbox.