Carrier ZS Pro - Primary Air Temperature Sensor

To Next Page

To Previous Page

Primary Air Temperature sensor

Part #33ZCSENPAT

The Primary Air Temperature (PAT) sensor monitors the supply air temperature. Use a PAT sensor if state or local

code requires the use of conduit. If conduit is not required, you can use an SAT sensor.

6 in.

(15.2 cm)

probe

4 x 2 in.

(10.2 x 5.1 cm)

electrical box

Primary Air Temperature sensor

Downloaded from ManualsNet.com search engine

Main Page

Table of Contents3
Introduction to Carrier Sensors5
ZS Sensors7
Specifications9
CO2 Sensor Installation10
Rnet Configuration10
Rnet Wiring Specifications10
To Address a ZS Sensor11
Power Requirements12
To Wire and Mount a ZS Sensor13
To Communicate through the Local Access Port15
Troubleshooting16
SPT Sensors18
SPT Sensor Specifications20
Rnet Configuration20
To Address an SPT Standard Sensor21
Rnet Wiring Specifications21
Mounting Location21
To Wire and Mount the SPT Sensor22
Using an SPT Sensor24
To Change Sensor Properties25
To Communicate through the Local Access Port26
Troubleshooting SPT Sensors27
Alternate Space Temperature Sensor28
Sensor Specifications29
Wiring Specifications30
Mounting Location30
To Wire and Mount the Sensor31
To Change a T59 Sensor's Options32
Supply Air Temperature Sensor35
SAT Sensor Specifications36
Wiring Specifications36
Mounting Location37
To Wire and Mount the SAT Sensor37
Duct Air Temperature Sensor38
DAT Sensor Specifications38
Wiring Specifications39
Mounting Location39
To Wire and Mount the DAT Sensor39
Outdoor Air Temperature Sensor40
OAT Sensor Specifications41
Wiring Specifications41
Mounting Location42
To Wire and Mount the OAT Sensor42
Primary Air Temperature Sensor43
PAT Sensor Specifications44
Wiring Specifications44
Mounting Location45
To Wire and Mount the PAT Sensor45
CO2 Sensor46
CO2 Sensor Specifications47
Wiring Specifications47
Mounting Location48
To Wire and Wall-Mount the CO2 Sensor49
To Wire and Duct-Mount the Sensor50
Co2/Temperature Sensor51
Co2/Temperature Sensor Specifications52
Wiring Specifications52
Mounting Location53
To Wire and Mount the Co2/Temperature Sensor53
Relative Humidity Sensors55
Sensor Specifications56
Wiring Specifications57
Mounting Location57
To Wire and Mount the Space RH Sensors58
Typical Power Wiring Diagrams for Space RH Sensors60
To Wire and Mount the Duct RH Sensor61
To Wire and Mount the Outdoor RH Sensor63
Typical Power Wiring Diagrams for Duct RH and Outdoor RH Sensors64
Calibrating and Troubleshooting Relative Humidity Sensors65
Enthalpy Switch/Receiver and Enthalpy Sensor67
Enthalpy Switch/Sensor Specifications68
Wiring Specifications68
Mounting Location68
To Wire and Mount the Switch/Sensor69
Appendix: I-Vu® Control System Wiring Specifications and Recommended Vendors71
Document Revision History72
Index73

Carrier ZS Pro - Primary Air Temperature Sensor

Table of Contents

Other manuals for Carrier ZS Pro

Related product manuals