Copies data from source HDD to targets. (There are four
copy modes for selection using function 6.1)
Compares data bit by bit between source and target
HDDs.
First copies, then compares target HDD with source HDD
to ensure data accuracy.
4.1 Quick Erase
Erases HDD’s index table only.
4.2 Full Erase
Erases whole HDD. Complies with NIST800-88 Standards.
4.3 DoD Erase
3-Pass erases the entire device capacity. Complies with
DoD5220.22-M Standards.
4.4 DoD EraseComp
3-Pass erases the entire device capacity and verifies.
Conforms to DoD5220.22-M Standards.
4.5 Secure Erase
Overwrites every single track on the hard drive with
"00". Even HPA/DCO or other data area that are not able
to load, can be erased all together.
5.1 Show Disk Info.
Shows HDD’s basic information such as HDD model name
and capacity.
5.2.1 Update BIOS
Updates system firmware via a USB pen
drive or a HDD.
5.2.2 Create Update HDD
Formats the HDD with a 2GB FAT partition
in order to quickly save firmware in the
HDD.
5.3 System Info.
Displays duplicator system information, such as,
controller model number and software version.
To Next Page
Loading...