Fig. 3-2
WARNING
When starting your MINI-Talon the kart should
never “buck” or move forward. As the rope is
pulled to start the engine, the inertia wheel spins.
If the kart moves or pulls forward as the rope
start is pulled, the rubber-molded disc is making
contact with the inertia wheel and must be
correctly adjusted prior to operation. If you are
unable to adjust, or feel uncomfortable
performing the adjustment, contact your dealer
for assistance.
ADJUSTMENTS
Fig. 4-1
WARNING
Prior to starting the engine, push the kart forward
then apply the brake. If the kart does not stop,
the brake is not adjusted correctly. Adjust the
brake for correct operation prior to using the
MINI-Talon. If you are unable to adjust, or feel
uncomfortable performing the adjustment,
contact your dealer for assistance.
Adjusting the Brake Cable
Fig. (4-1) depicts the brake caliper with the
brake cable correctly installed. The brake
cable sleeve (A) must fit inside the keeper (B)
as shown.
Remove the bottom cover of the rear end.
With a #5 Metric Allen head, loosen the brake
cable retaining bolt (C). Push up on the brake
actuator (D) as shown (Fig. 4-2) and pull the
brake cable (E) until it is tight. While
maintaining pressure on the actuator, tighten
the cable retainer bolt (C).
15
To Next Page
Loading...